GENERAL DESCRIPTIONTECAPEEK ® is a unique semi-crystalline, high temperature engineering thermoplastic based upon the PolyEtherEtherKetone (PEEK) or PolyArylEtherKetone (PAEK) polymers. It is an excellent material for a wide spectrum of applications where mechanical, thermal, and chemicaln properties are critical to performance.
Especially significant, in this regard, is TecaPEEK's ability to retain its flexural and tensile properties at very high temperatures in excess of 250°C (482°F). The addition of glass fiber (TECAPEEK GF30) or carbon fiber (TECAPEEK CF30) reinforcements enhances the mechanical and thermal properties of the basic TecaPEEK ® material. A self-lubricated grade, TECAPEEK PVX is also manufactured for low friction and increased wear resistance in bearing applications.
TecaPEEK ® is produced only by Ensinger Industries and is available in sheet/plate, solid round rod, and rigid tube forms for machining into parts.
TECAPEEK ® CF30
TecaPEEK ® CF30 material contains 30% carbon fibers, providing the ultimate in tensile and flexural modulus (stiffness), with excellent properties up to 600°F (315°C), while increasing the material's thermal and electrical conductivity.
Carbon-filled TecaPEEK is available in pre-molded sheet, solid round rod and thick-walled cylindrical tube shapes and is black in color.
TYPICAL PROPERTIES of TECAPEEK ® CF30
|ASTM or UL test||Property||TecaPEEK CF30
|D570||Water Absorption, 24 hrs (%)||0.06|
|D570||Water Absorption, Saturation (%)||-|
|D638||Tensile Strength (psi) @ Yield||27,000|
|D638||Tensile Modulus (psi)||1,885,000|
|D638||Tensile Elongation at Yield (%)||-|
|D638||Tensile Elongation at Break (%)||1.1|
|D790||Flexural Strength (psi)||46,100|
|D790||Flexural Modulus (psi)||1,850,000|
|D732||Shear Strength (psi)||14,100|
|D695||Compressive Strength (psi)||34,800|
|D256||Izod Impact, Notched (ft-lbs/in)||0.9|
|D785||Hardness, Rockwell M||M107|
|-||Limiting PV (psi-ft/min)||385,000|
|-||Coefficient of Friction
(1200 in/min, 155 lb load)
|E-831 (TMA)||Coefficient of Linear Thermal Expansion
(x 10-5 in./in./°F)
|D648||Heat Deflection Temp (°F / °C)
at 264 psi
600 / 315
|D3418||Melting Temp (°F / °C)||633 / 333|
|-||Max Continuous Service Temp (°F / °C)||500 / 260|
(x 10-4 cal/cm-sec-°C)
|D149||Dielectric Strength (V/mil) short time, 1/8" thick||-|
|D257||Volume Resistivity (ohm-cm)||-|
|D257||Surface Resistivity (ohms per square)||-|
NOTE: The information contained herein are typical values intended for reference and comparison purposes only. They should NOT be used as a basis for design specifications or quality control. Contact us for manufacturers' complete material property datasheets.TECAPEEK is a registered trademark of Ensinger Industries, Inc.
All values at 73°F (23°C) unless otherwise noted.