Boedeker Plastics, Inc. Logo -- boedeker plastics supply shiner
     texas tx usa boedeker plastics material supply shiner texas usa plastics
     distributor plastics sales plastics supply plastics machine shop

Kadel® Polyketone Specifications

904 West 6th Street, Shiner, Texas 77984 USA
Phone: 1-361-594-2941     Fax: 1-361-594-2349     E-Mail: info@boedeker.com

1-800-444-3485

BPI Home Page | Applications | Materials Guide | Contact Us!

blue line

GENERAL PROPERTIES
Kadel® Polyketones have outstanding high temperature resistance (above 500°F / 260°C), exceptional chemical resistance, excellent mechanical properties, and high PV wear resistance. They provide a wide range of cost/performance options.

Typical Kadel® applications include chemical processing, aviation and aerospace composites, compressor parts, bearings and seals, wire and cable coatings, and wear rings.

NOTE: Kadel has been discontinued by the manufacturer, but contact us for information about Solvay's replacement product, AvaSpire 621 PAEK.

blue line


TYPICAL PROPERTIES of KADEL® PAEK

ASTM or UL test Property Kadel®
PHYSICAL
D792 Density (lb/in³)
(g/cm³)
0.050
1.37
D570 Water Absorption, 24 hrs (%) 0.07
MECHANICAL
D638 Tensile Strength (psi) 23,700
D638 Tensile Modulus (psi) 1,410,000
D638 Tensile Elongation at Yield (%) 2
D790 Flexural Strength (psi) 34,100
D790 Flexural Modulus (psi) 1,450,000
D695 Compressive Strength (psi) -
D695 Compressive Modulus (psi) -
D785 Hardness, Rockwell -
D256 IZOD Notched Impact (ft-lb/in) 1.8
THERMAL
D696 Coefficient of Linear Thermal Expansion
(x 10-5 in./in./°F)
1.06
D648 Heat Deflection Temp (°F / °C)
at 264 psi

619 / 326
D3418 Melting Temp (°F / °C) -
- Max Operating Temp (°F / °C) 520 / 271
C177 Thermal Conductivity
(BTU-in/ft²-hr-°F)
(x 10-4 cal/cm-sec-°C)

-
-
UL94 Flammability Rating V0
ELECTRICAL
D149 Dielectric Strength (V/mil) short time, 1/8" thick 369
D150 Dielectric Constant at 1 KHz 3.7
D150 Dissipation Factor at 1 MHz -
D257 Volume Resistivity (ohm-cm)at 50% RH 1.6 x 1018

NOTE: The information contained herein are typical values intended for reference and comparison purposes only. They should NOT be used as a basis for design specifications or quality control. Contact us for manufacturers' complete material property datasheets.
All values at 73°F (23°C) unless otherwise noted.
KADEL and AVASPIRE are registered trademarks of Solvay Advanced Polymers.

blue line

http://www.boedeker.com/kadel.htm

Boedeker Plastics, Inc.
904 West 6th Street, Shiner, Texas 77984 USA
USA TOLLFREE : 1-800-444-3485
Phone: 1-361-594-2941     Fax: 1-361-594-2349     E-Mail: info@boedeker.com

©     Copyright Boedeker Plastics, Inc.