GENERAL DESCRIPTIONDuratron ® PolyEtherImide (PEI) is an amber transparent high performance polymer which combines high strength and rigidity at elevated temperatures with long term heat resistance. PEI offers excellent dimensional stability combined with broad chemical resistance.
Duratron® U2100 PEI (10% glass filled)
Glass reinforced Duratron® U2100 provides even greater rigidity and dimensional stability while maintaining many of the useful characteristics of basic PEI®. The glass reinforcement yields a product with an exceptional strength-to-weight ratio and increased tensile strength.
This glass-reinforced grade is NOT AVAILABLE FROM STOCK, but rather can be offered ONLY BY SPECIAL ORDER ... long leadtimes and large minimum order quantities may apply when ordering these grades in sheet or rod forms.
Other available Duratron PEI grades include unfilled Duratron U1000 PEI, 20% glass-reinforced Duratron U2200 PEI, and 30% glass-reinforced Duratron U2300 PEI. For a side-by-side properties comparison of the Duratron U PEI grades, see this page.
For a complete overview of Quadrant's Duratron product family, including other high-performance engineering plastics, see this page.
TYPICAL PROPERTIES of DURATRON® U2100 PEI POLYETHERIMIDE
|ASTM or UL test||Property||Duratron® U2100
|D570||Water Absorption, 24 hrs (%)||0.21|
|D570||Water Absorption, Saturation (%)||1.20|
|D638||Tensile Strength (psi)||16,600|
|D638||Tensile Modulus (psi)||650,000|
|D638||Tensile Elongation at Break (%)||6|
|D790||Flexural Strength (psi)||28,000|
|D790||Flexural Modulus (psi)||650,000|
|D695||Compressive Strength (psi)||22,000|
|D695||Compressive Modulus (psi)||540,000|
|D785||Hardness, Rockwell||M114 / R127|
|D256||IZOD Notched Impact (ft-lb/in)||1.1|
|D696||Coefficient of Linear Thermal Expansion
(x 10-5 in./in./°F)
|D648||Heat Deflection Temp (°F / °C)
at 264 psi
405 / 207
|D3418||Glass Transition Temp (°F / °C)||419 / 215|
|-||Max Operating Temp (°F / °C)||340 / 171|
(x 10-4 cal/cm-sec-°C)
|D149||Dielectric Strength (V/mil) short time, 1/8" thick||-|
|D150||Dielectric Constant at 1 KHz||3.5|
|D150||Dissipation Factor at 1 KHz||0.0014|
|D257||Volume Resistivity (ohm-cm)at 50% RH||1.0 x 1017|
NOTE: The information contained herein are typical values intended for reference and comparison purposes only. They should NOT be used as a basis for design specifications or quality control. Contact us for manufacturers' complete material property datasheets.DURATRON is a registered trademark of Quadrant Engineering Plastic Products.
All values at 73°F (23°C) unless otherwise noted.